Teac D-07x - Manual (Page 20)

20
1 Connect this unit to a computer using a USB
cable.
Use a cable with a connector that matches that of this unit.
Personal computer
2 Turn the computer power on.
Confirm that the operating system has started properly.
3 Press the POWER button to turn this unit on.
4 Press the INPUT button repeatedly to select
USB (see page 11).
5 Start playback of an audio file on the computer.
Better sound quality can be achieved by setting the volume on
the computer to the maximum level and using the amplifier con-
nected to this unit to adjust the volume. Set the amplifier volume
to the minimum when you start playback and gradually increase it.
o The computer cannot control this unit, nor can this unit control
the computer.
o This unit cannot send audio files to the computer by USB.
o Do not do any of the following when playing back an audio file
via USB. Doing so could cause the computer to malfunction.
Always quit the music playback software before doing any of the
following.
Unplug the USB cable
Turn this unit's power off
Change the input
o When playing back an audio file via USB, computer operation
sounds will also be output. If you do not want these sounds to
the output, make appropriate settings on the computer to turn
them off.
o If you connect this unit with the computer or change its input to
“USB” after starting the music playback software, audio files might
not play back correctly. If this should occur, restart the audio play-
back software or restart the computer.
Connecting a computer and playing back audio files (2)