Teo 6001TA - Manual

13-102862 Rev. H
November 2005
The Model 6001 Terminal Adapter allows a Tone Commander 6210 or 6220 ISDN telephone to be
controlled by a TAPI-compliant Windows computer application program. Adapter circuitry is housed in a
telephone base that replaces the standard base. An RS232 serial port on the base connects to the
computer's com port.
A Windows TSPI driver, available for download from www.tonecommander.com, is required to use the
features of the 6001TA. You will also need TAPI-compliant Windows application program.
PhoneLink™ for Outlook
®
, a free basic call alerting and control application that integrates with Microsoft
®
Outlook, can be downloaded from www.tonecommander.com. The TSPI driver is included with PhoneLink
for Outlook. Several TAPI-compliant programs are available from other vendors.
Telephone operating software must be version 01.03.02 or higher to enable the TAPI features. To
view the installed software version, select VERS, then S/W from the Administration Options menu (Setup
→ ADMIN→ VERS→ S/W). If your phone's software version is lower than 01.03.02, call Tone Commander
at (800) 524-0024 to request an update.
Terminal Adapter Installation
Mounting the Base
Refer to the illustration on the following page.
1. Disconnect the line cord.
Power must be disconnected before installing the 6001TA.
Wait 10 seconds after disconnecting power before proceeding.
2. Remove the retaining screw in the center of the base.
3. Press the top of the tall edge of the base to disengage the snap tabs, then lift the base from the
telephone body. Do not touch the expansion connector.
4. Plug the cable from the terminal adapter base into the expansion connector on the telephone. The
polarization tab on the plug must fit into the opening on the side of the phone connector.
5. Snap the terminal adapter base onto the phone. The base may be rotated for wall mounting.
6. Replace the retaining screw (required for UL compliance).
6001TA Terminal Adapter
Installation Instructions