Tiffen Lowel PRO Power LED - Manual

Lowel PRO Power LED Instructions
The Lowel PRO™ Power LED
is a professional AC/DC powered
lighting fixture. Read these instruc-
tions before operating.
n Not for house hold use,
use only for professional imaging
purposes.
n Do not immerse unit in water
or use in damp locations.
n Do not obstruct heat ventilation
for unit.
n Do not stare directly into LED’s.
n Always remove batteries
or AC supply, and make sure unit
is powered Off when not in use,
or being stored.
Warnings
Yellow Dot = Tungsten Model
Code: G5-10TU
Blue Dot = Daylight Model
Code: G5-10DA
Lowel PRO Power LED is available as
either a tungsten color, or daylight color out-
put model. In either case, color does not shift
as the light is dimmed.
An 82mm filter can be attached to the screw
thread on the front of PRO's fresnel lens.
This allows color conversion filters, to turn a
tungsten light to daylight and vice versa.
Daylight / Tungsten Filter Conversion
n Steady Green – Unit is ON and has
sufficient power (battery or AC)
n Slowly Flashing Green – Unit has
battery power for aprox. 10 minutes at full
brightness
n Fast Flashing Green – Unit has battery
power for aprox. 2-3 minutes at full
brightness.
n Flashing Red – Unit is overheating and
is about to shut down. Turn Power Switch
OFF and let unit cool for 10-15 minutes.
Indicator Lamp
Fold down 1/2 yoke to mount PRO Power
LED on 5/8" stand stud. Tighten knob
securely. Fold down rear handle to assist in
tilt & focus control. Attach power cord from
AC supply (Or Battery Accessory) into the
jack on the rear of the light, making sure
to correctly orient the mini-XLR plug.
Turn PRO on with the On / Off Switch,
and adjust dimmer level for desired output.
Color temperature will not shift during
dimming.
Operation
Focusing
Weight (w/barndoors): 3.3 lbs (1.5 kg)
1 Lowel PRO (Tungsten or Daylight) with
auto-setting AC adaptor (G5-80), and 2 Way
Barndoors (G5-25)
Voltage: 24 V
Wattage: 22.4 W Amperage: .7 A
Beam control: Continuously variable
Fits on: 5/8 stand studs, also 1/4-20 Pistol
Grip mount
Materials: Primarily aluminum steel,
& glass-filled nylon Dimming Control & Switch: in-unit
Installed LED Lumen information:
2292 lumens (3000K Tungsten Model)
2500 lumens (5000K Daylight Model)
both at 700mA drive current (17.6W)
Lowel PRO Accessory
Battery System
Code: G5-156
Weight: 3.6 lbs (1.6 kg)
Battery box with 7ft DC cord, attached stand
mount clamp, air-cushioned shoulder strap,
and removable PRO LED Long Life Battery
(G5-15). Supplied with Lowel Rapid Charger
100 (G1-18)
Lowel PRO Spare Battery
Code: G5-15
Weight: 1.5 lbs (.7 kg)
Lowel PRO Spare Battery Box
Code: G5-17
Weight: 1.3 lbs (.6kg)
Rapid Charger 100
Code: G1-18
Weight: .8 lbs (.4 kg)
Powering PRO Power LED by Battery
Lowel PRO Power LED is a focusing fixture with a spot to flood ratio of 5:1.
To focus, hold the light by its rear handle as you grasp the front of lighthead and slide it for-
ward to spot, or backward to flood the beam.
Focusable
LED Head
with Fresnel
Lens
Accessory Slot
Diaphragm
Cooling
Fold Down Handle
Tilting Half Yoke
1/4-20 Screw
Thread
Barndoor Frame
Attachment Ring
Folded for storage with Barndoors attached.
Spot Flood
Dimmer Knob
On/Off
Switch
Indicator
Lamp
Power In
Specs & Daylight & Tungsten Models