Tri Tool 600RBL and 600SB Series OD Tracking Module - Manual (Page 17)

17
Model 600 SB and RBL OD Tracking Module
92-0732 Rev. 131009
7.02 CUTTING FEEDS
• Use a very light feed for initial severing or until a continuous cut is
established.
• Use a feed rate of .002” to .003” (.05 mm to .08 mm) per revolution after a
continuous cut is established.
• If the feed is too light, only light stringer chips are removed.
• If the feed is too heavy, the drive will overload and the chip will be rough or
torn.
• Stainless steel, which work hardens, must be cut with just a heavy enough
feed to stay under the work hardened surface.
• Feed at rate of at least .003” to .005” (.08 mm to .13 mm) per revolution.
• Never allow the Tool Bit to burnish the surface.
• Reducing cutting feed and speed usually minimizes chatter problems.