Tri Tool 602-5SBM Clamshell Air - Manual (Page 26)

26
TRI TOOL INC.
92-0093 Rev. 131230
WARNING:
TOOL BIT SET-UP
Select the proper Tool Bit set (Refer to “Tool Bits”)
The use of dull or improperly designed Tool Bits or Tool Bits not manufactured
by Tri Tool Inc. may result in poor performance and may constitute abuse of
this machine and therefore voids the Tri Tool Inc. factory warranty.
Install the tool Bits into the Tool blocks. Refer to “Tool Bits” for installation drawings.
Approximately .50” (13 mm) should be protruding from the end of the Tool Holders.
Tighten the Tool Bit Set Screws, then verify that there is adequate clearance
between the Tool Bits and the pipe by rotating the Headstock by hand.
The Leading Tool Bit should contact the pipe approximately .020” to .040” (.51 mm
to 1.02 mm) before the Trailing Tool Bit.
Go to ”General machining sequence”.
Pad Set Selection
Pipe Size OD P/N of Pad Sets
3.000 76.2 mm 67-3178
2 1/2" 2.875 73.0 mm 67-3179
2.750 69.9 mm 67-3159
2.625 66.7 mm 67-3181
2.500 63.5 mm 67-3182
2" 2.375 60.3 mm 67-3183
2.250 57.2 mm 67-3184
2.125 54.0 mm 67-3185
2.000 50.8 mm 67-3186
1 1/2" 1.900 48.3 mm 67-3187
1.875 47.6 mm 67-3188
1.750 44.5 mm 67-3189
1 1/4" 1.660 42.2 mm 67-3190
1.625 41.3 mm 67-3191
1.500 38.1 mm 67-3192
1.375 34.9 mm 67-3193
1" 1.315 33.4 mm 67-3194