Tri Tool SQM-1AC Squaring Module - Manual (Page 11)

11
Model SQM-1AC Squaring Module
92-0675 : Rev. 970314
WARNING:
Slide the tool bit into the desired position for the diameter of the pipe or tube to be
machined.
Tighten the (3) three set screws to secure the tool bit.
Turn the Model 572AC on and let it rotate slowly while ensuring that the tool bit is
not making contact with the end of the pipe.
Bring the motor up to speed.
Turn the feed knob to feed the tool bit into the end of the pipe.
After the face of the pipe has been machined let the tool bit make three more
rotations to clean up the face.
Back the tool bit off of the pipe by turning the Feed Knob.
Damage to the gear box will occur if the white line on the tool holder is
retracted beyond where it can be seen.
Turn off the motor.