TS Performance 4110104 - Manual (Page 2)

Continued
Installation of the TS Performance John Deere Agri-
Power module.
Read all instructions and fully understand them before installing you TS Performance John Deere
Agri-power module. Disconnect the battery terminals and remove keys from ignition before
installation.
Place Di-Electric Grease onto every electrical connection.
Instructions for installation of early model dual rail
9200,9300, 9400 tractors.
1. Locate the two wire sensor at the back of the engine head.
2. Unplug the connector from the sensor; plug the connector from the John Deere harness in to the
sensor.
3. Now plug the factory sensor in to the left over connector.
4. The John Deere comes with two 1/4” zip ties to mount the box in a dry cool location.
5. Route the cables away from any moving parts or places that might damage the cable with the 4” zip
ties supplied.
Instructions for installation of late model single rail
9220,9320, 9420, and 9620 tractors.
1. Find the two wire sensor located on the front-left of engine block behind the fuel filter.
2. Unplug the connector from the sensor; plug the connector from the John Deere harness in
to the sensor.
3. Now plug the factory sensor in to the left over connector.
4. The John Deere comes with two 1/4” zip ties to mount the box in a dry cool location.
5. Route the cables away from any moving parts or places that might damage the cable with
the 4” zip ties supplied.
DO NOT unplug the MP-8 Module while the engine is running. This may result in
engine or component failure and may void warranty on the engine or MP-8.
If there are any questions on the product or installation of the module give us a call at TS Performance
(270) 746-9999