TS Performance 1110203 - Manual (Page 3)

Continued
1. Find the proper location for mounting the module itself.
This should be a dry location using the supplied Velcro to
securely mount it.
2. Route the switch wire through the firewall to the MP-8.
We recommend making a small hole in a boot and running
the wire through there. Make sure not to cut any wires
when making the hole.
3. Locate the MAP Sensor. The connector will be a three pin
connector as seen in the picture. Use the supplied
connectors and plug into the MAP Sensor and factory
harness.
On the LBZ & LMM engine the MAP Sensor is located on
the front air intake manifold tube on the front of the engine
as shown in the picture to the right.
4. Now you will need to locate the Fuel Pressure Connector.
On the LBZ and LMM engines the Fuel Pressure
Connector is located on the passenger’s side valve cover.
There are 2 connectors side by side and you will want to
disconnect the black connector. Now connect our harness
to the male and female side of this connector.
5. Now you need to decide where you want to mount your
adjustable switch. We suggest using the area just to the
left of the airbag shut-off switch. If you do not want to
drill your dash you can also hang the switch beside the
steering column.
A Shim Kit must also be installed when installing the MP-8 module. If the shim kit is
not installed correctly it can set a Check Engine Light. Your Shim Kit Instructions
are listed in a separate set of instructions.
If there are any questions on the product or installation of the module give us a call at TS Performance
(270) 746-9999