TS Performance 1110402 - Manual (Page 2)

Continued
Installation of the TS Performance Power Play Mp-8
Ford 6.4L
Read all instructions and fully understand them before installing you TS Performance MP-8 module.
Disconnect the battery terminals and remove keys from ignition before installation.
Place Di-Electric Grease onto every electrical connection.
1. Find a proper location for mounting the
module. Use the supplied Velcro to
fasten the module away from extreme
heat and moisture.
2. Locate the 15 pin connector found on
the passenger side of engine. The fuel
sensor signal and power wires are
integrated into this connector.
3. Disconnect the plug and connect our
supplied connectors in-line.
4. Route the adjustable switch wire
through the firewall to the MP-8
module.
5. Mount the switch on the dash where it
can be accessed by the drive.
6. Re-connect the battery terminals.
If there are any questions on the product or installation of the module give us a call at TS Performance
(270) 746-9999