TS Performance 1110501 - Manual (Page 2)

Continued
Installation of TS Performance Power Play MP-8
Jeep Liberty 2.8L
Read all instructions and fully understand them before installing your TS Performance MP-8 module
disconnect the battery terminals and remove keys from the ignition before installation.
Place Di-Electric Grease onto every electrical connection.
1. First you need to find the proper location
four mounting the module. We
recommend the fuse box located on the
driver’s side of the engine compartment in
front of the battery. Velcro the module to
the fuse box.
2. Remove the oil fillet cap and plastic
engine cover. This will allow you to see
the sensors that you need to plug into.
3. Locate the MAP Sensor, It will be
located on the driver’s side of the engine
toward the rear, just below the wiper
cowl. It will have a 4 Pin connector
plugged into it. Disconnect the factory
connector and plug it into our harness,
and our harness into the sensor.
4.
Locate the Fuel Pressure Sensor just in
front of the MAP Sensor. It will have an
orange grommet when disconnected and
will be a 3 pin connector. Plug the
factory connector into our harness and our
harness into the sensor.
5.
Mount the switch in the dash in an area
the driver can access easily.
6.
Route the adjustable switch through the
firewall and to the MP-8 module.
7.
Before finishing be sure that all the
connections are tight. Now re-install the
plastic engine cover, tighten the oil fill
cap, and re-attach the batteries.
If there are any questions on the product or installation of the module give us a call at
TS Performance (270) 746-9999