TS Performance 2110102 - Manual (Page 2)

Continued
Installation of TS Performance Power Play MP-8
International DT466
Read all instructions and fully understand them before installing your TS Performance MP-8
module. Disconnect the battery terminals and remove keys from the ignition before installation.
Place Di-Electric Grease onto every electrical connection.
1. Locate a place to mount the MP-8 module inside the engine compartment on the driver’s side
where it will be free from extreme heat and moisture. Use the supplied zip ties to securely
mount the module.
2. Locate the ICP Sensor on the driver’s side of the engine block toward the back of the engine.
The plug will on the same line as the injector plugs it will be the fifth plug from the front of the
engine on the row of injector plugs.
3. Route the wire from the adjustable switch through the firewall to the module.
4. Mount the switch in a location the driver can easily access.
If there are any questions on the product or installation of the module give us a call at TS
Performance (270) 746-9999
ICP SENSOR