TS Performance 5120100 - Manual (Page 2)

Continued
Wiring Instructions
There are 7 Wires to be Connected
1. Red: Power supply for the Loc-
Up box. Connect to fused 12V +“ignition on” power source.
2. Black: Must connect eyelet to good clean ground.
3. Brown wire connects to the transmission side of the torque converter clutch (TCC) wire.
4. Orange wire connects to the PCM side of the TCC wire.
5. Yellow wire connects the positive side of the (VSS) vehicle speed sensor wire.
6. Green wire will connect to an Autometer sender #2385 for temp readings.
Dodge:
Torque Converter Wire Hook-Up
• Unplug transmission harness connector on driver’s side.
(94-95) Has a Yellow three pin connector; locate wire going to rear pin.
(96-UP) Has a Black eight pin connector; locate Orange w/Black stripe going to pin # 7.
• Cut this wire and use a butt connector to connect the Brown wire to the transmission side of the
wire.
• Then on the same wire you cut use a butt connector to connect the Orange wire to the ECM
side.
Vehicle Speed Sensor Hook-Up
• Locate wires coming from VSS sensor on top of differential. Locate, identify, and follow these
wires thru frame rail to the
driver’s side area behind the front fender weld.
• You will see two connectors here. Look for the only twisted pair of wires wrapped in black tape.
Do not cut this wire only tap into the wires.
• Red w/Purple tracer is the positive side. Using supplied crimp on connector, connect and plug
the yellow wire to Red w/Purple tracer. Tap into the white wire with purple tracer (negative side).
Connect other end to the black ground wire at controller.
94-95 will skip this section.
Ford:
Torque Converter Wire Hook-Up
• Locate the connector on the passenger side of the transmission, Unplug and locate the Purple
w/Yellow tracer will be on the inside row of connector 4 hole from rear of truck.
• Cut this wire and use a butt connector to connect the Brown wire to the plug (transmission) side
of the wire.
• Then on the same wire you cut use a butt connector to connect the Orange wire to the ECM
side.
Vehicle Speed Sensor Hook-Up
• Locate wires coming from VSS sensor on top of differential.
• Follow these wires thru frame rail. Will be the only twisted pair of wires wrapped in Black tape.
Do not cut this wire only tap into the wire.
• Locate the Red with Black tracer and tap connect the Yellow wire. Tap into the green wire with
black tracer (negative side). Connect other end to the black ground wire at controller.
Duramax:
Torque Converter Wire Hook-Up
• Unplug the connector on the passenger side of the transmission (oval shape).
• Locate the wire in pin J, should be a dark grey wire with white tracer.
• Cut this wire and use a butt connector to connect the Brown wire to the transmission side of the
wire.
• Then on the same wire you cut use a butt connector to connect the Orange wire to the ECM
side.