Venstar T1100FS - Manual (Page 12)

Press
Press
Select Yes to copy the
previous day’s program
to the day displayed.
If Yes is selected:
If No is selected:
The copy command becomes available after
programming the entire previous day.
If No is selected, as in previous steps, flashing prompts for
input will appear for the four time periods for the next day.
Yes
No
MODE
MODE
Programming a Daily Schedule
Selecting Yes, then pressing MODE will
copy the previous day’s program. If yes
is selected again, or each time, this
routine will repeat.
MODE
After programming for all seven days is complete, press
the MODE and UP buttons at the same time for two seconds
to leave the Setup screens. If no buttons are pressed, the
display will leave the setup screens after 30 seconds.
Tu
Page 11