Venstar T1100RF - Manual (Page 6)

MODE
FAN
Quick Start Set the Clock and Go
2
Setup
M
Press
MODE
Setup Am
I2 00 i
:
Press the MODE button.
W h i l e h o l d i n g M O D E ,
press the FAN button for
two seconds to enter Setup
screens.
MODE
FAN
buttons.
To adjust the
Clock or Day use
During Setup & Programming:
Pressing the UP or DOWN
button will modify the
flashing selection.
The thermostat is preprogrammed from the factory to operate
one or two stage equipment* without the need for further
programming. To optimize the installation of this thermostat,
follow the instructions in the Advanced Setup section.
* The thermostat is not preprogrammed from the factory to operate
electric heat or heat pump systems. To control these systems,
follow the instructions in the Receiver manual.
Setting the Clock
Setting the Day
Tip: To change hours
quickly, press and
hold the FAN button,
then press the UP or
DOWN button.
Press the MODE button.
W h i l e h o l d i n g M O D E ,
press the FAN button for
two seconds to enter Setup
screens.
Page 5