Verilink WANsuite 5330 (34-00302.F) Product Manual - Manual (Page 21)

A b o u t t h e W A N s u i t e 5 3 3 0 1-7
Rear Panel Connections
The rear panel of the WANsuite 5330 has five connectors
−
POWER ,
SUPERVISORY PORT , 10/100 ETHERNET , SERIAL INTERFACE , and NET
−
as shown in Figure 1.2 below.
Figure 1.2 WANsuite 5330 Rear Panel
Supervisory Port
The SUPERVISORY PORT is a DB-9 female DCE connector configured for 8
bits, no parity, and 1 stop bit. Bit rates are configured through the Web server
or VT100 interface. The Supervisory port speed can be set to 1200, 2400,
4800, 9600, 19200, 38400, 57600, or 115200 bps. The initial default rate of
the Supervisory port is 19.2 kbps.
On power-up, the Supervisory port sends out diagnostic messages at the bit
rate of 115.2 kbps until the supervisory service acquires the Supervisory port,
after which the port speed is changed to the setting in the Supervisory
interface screen.
NOTICE: For information on pinout assignments for this connector, refer to
Supervisory Port Pin Assignments on page A-7. See Ordering
Information on page A-4 for information on cables for this connector.
10/100 Ethernet
The WANsuite 5330 provides one 10/100 ETHERNET interface for SNMP and
Web browser access. This interface is an eight-pin modular jack that complies
with standard twisted-pair, 10/100Base-T requirements. The 10/100Base-T
cable is supplied by the end user. Refer to Ethernet Interface Pin Assignments
on page A-6 for pin assignments and cable descriptions.
Ethernet LED Indicators
There are two unlabeled indicator LEDs on either side of the 10/100 Ethernet
jack. The LED on the left side of the jack pulses amber to indicate data
activity (either transmit or receive). The LED on the right side of the jack
lights green to indicate that the link layer is operational.