Viante CUC-25PM Pasta Maker Quick Guide User Manual
Page 5
he various components need to be assembled in the following order:
Introduce the mixing blade in the mixing chamber (
Image 1
). The rear end should go in first. After the front end is in
place, the mixing blade should be straight and in place. Once it’s in place the metal shaft should be inserted.
Insert the thin end of the steel rod/shaft into the opening of the mixing chamber and then the mixing paddle. Push it
through until it is fully inserted. You may need to rotate the steel rod slightly in order for it to fit into place. (
Image 2
)
Guide the mixing chamber into the motor base. Align the steel rod and the arrow-shaped lock on top of the mixing
chamber with the small openings at the back of the motor base. (
Image 3
)
Twist and slightly lift the mixing blade until it fits comfortably into the slot. Once correctly inserted, it will “click” into
place.
Fully insert the steel end of the extrusion screw in the opening of the extrusion chamber and twist it until it “clicks”
into place. (
Image 4
)
Select your desired pasta disc and position it on the opening of the extrusion chamber so that the small grooves on the
disc fit comfortably on the three tabs of the extrusion chamber opening. (
Image 5
).
Secure the disc by placing the disc holder over the opening of the extrusion chamber and tighten it by screwing it in a
clockwise direction. (
Image 6
)
T
1
2
3
4
5
6
1
2
3
4
5
7
6