WallWizard X700CB Control Box Replacement - Manual (Page 2)

X-arm Control Box Replacement (Continued)
IR Receiver IR Receiver Soccket Soccket
Set Set
Selector Selector
Screen Size Screen Size
POWER POWER
11.
Attach the power cord and IR Receiver.
Plug the X-arm into a grounded power outlet.
Line up the three hooks on the control box
with the slots in the X-arm.
Slide the control box onto the X-arm.
8.
Attach the control box cover. 9.
Secure the control box to the X-arm with the
screws from the old control box. 10.
13.
13-1. Press the POWER switch to ON (1).
13-2. Measure the total width of the TV
including any side speakers that
may be attached to the TV.
13.3. Insert the provided plastic pointer
into the Selector hole, and press
the button until the TV width code
corresponds to the outside width of
your TV (see below).
Code TV Outside Width
C1 40” - 44.9” (102 - 113 cm)
C2 45” - 48.9” (114 - 123 cm)
C3 49” - 55.9” (124 - 140 cm)
C4 56” - 61.0” (141 - 155 cm)
13.4. Hold the Set button until the LED
display stops blinking.
IR Receiver Soccket
Set Set
Selector
Screen Size
POWER
Set the TV size code (see below).
14.
Recalibrate the X-arm to your TV.
To avoid damage, X-arm must be in the home
position before you calibrate it.
15.
Mount the TV as shown in your manual.
15-1. Switch off the main power on the side
of X-arm.
15-2. Hold down the Set button on the
control box while switching on the
power. Continue holding down the Set
button for 5 seconds until the display
reads CT.
15-3. Stand back while X-arm™ calibrates,
moving in - out, left - right and up -
down.
15-4. X-arm™ is done calibrating when it
goes back to the home position against
the wall.
IR Receiver IR Receiver Soccket Soccket
Set Set
Selector Selector
Screen Size Screen Size
POWER POWER
IR Receiver IR Receiver
Soccket Soccket
Set Set
Selector Selector
Screen Size Screen Size
POWER
IR Receiver Soccket
Set
Selector
Screen Size
POWER
12. If X-arm is in the home position against the wall,
continue to step 13. If not, follow these steps to get
X-arm into the home position:
12-1. Press the POWER switch to ON (1).
12-2. Insert the provided plastic pointer
into the Selector hole, and press
the button until the LED reads “t”.
12.3. Use the remote control to straighten
X-arm so that it is parallel with the
wall. Once parallel with the wall,
press the “Set” button on the control
box for three seconds. X-arm
should return to the home position.
R1: 4-3-07