Extron electronic RGB 324 - Manual

1-2 RGB 324, RGB 326, RGB 340 • Specifications
Specifications — RGB 324, RGB 326, RGB 340
Video
Gain ............................................... Unity (0.7V p-p), (0.8V p-p) 15% with 3dB peaking, (0.9V p-p) 30% with 6dB
peaking
Bandwidth .................................... 300 MHz (-3dB)
Video input
Number/signal type ................... 1 analog RGBHV, RGBS, RGsB, RsGsBs
Connectors .................................... 1 9-pin D male analog for MBC/LBC cable
Minimum/maximum levels ...... Analog ....... 0.3V to 1.45V p-p with no offset at unity gain
Impedance .................................... 75 ohms or Hi Z, switchable (set to 75 ohms if no local monitor is connected)
Horizontal frequency .................. 15 kHz to 100 kHz (optimum 15 kHz to 62 kHz)
Vertical frequency ....................... 30 Hz to170 Hz
Video output
Number/signal type ................... 1 analog RGBHV, RGBS, RGsB, RsGsBs
Connectors .................................... 5 BNC female
Minimum/maximum levels ...... Analog ....... 0.7V to 0.9V p-p (internal jumper-selectable) with 0.7Vp-p input and
peaking
Impedance .................................... 75 ohms
Return loss .................................... -48dB @ 5 MHz
Sync
Input type ..................................... RGBHV, RGBS, RGsB, RsGsBs
Output type .................................. RGBHV, RGBS, RGsB, RsGsBs; TTL buffered to RGB 320 control unit
Input level ..................................... 3.0V to 5.0V p-p (referenced to ground)
Output level .................................. 4.0V to 5.0V p-p
Input impedance .......................... 10 kohms
Output impedance ....................... 75 ohms
Max propagation delay ............... 45 nS
Max. rise/fall time ....................... 3.9 nS
Polarity .......................................... Positive, negative
Audio — buffered to RGB 320
Gain ............................................... Unbalanced 0dB, balanced +6dB
Frequency response ..................... 20 Hz to 20 kHz, ±0.05dB
THD + Noise ................................ 0.03% @ 1 kHz, 0.3% @ 20 kHz at rated maximum output drive
S/N ................................................ >90dB at rated maximum output (17dBu), balanced
Stereo channel separation ........... >95dB @ 1 kHz to 20 kHz
Audio input — buffered to RGB 320
Number/signal type ................... 1 stereo, unbalanced; 1.0Vrms (+4dBu), 20 Hz to 20 kHz
Connectors .................................... 3.5 mm stereo jack (2 channel), unbalanced; tip (L), ring (R), sleeve (ground)
Impedance .................................... >10 kohms unbalanced, DC coupled
Minimum level ............................. 100mV
Maximum level ............................ +8.5dBu
Audio output — buffered to RGB 320
Number/signal type ................... 1 buffered, stereo (2 channel), balanced/unbalanced
Connectors .................................... 1 3.5 mm captive screw connector, 10 pole
Impedance .................................... 50 ohms unbalanced, 100 ohms balanced
Gain error ...................................... ±0.1dB channel to channel
Maximum level
(into RGB 320 audio input) .......... > +16dBm, balanced at stated %THD+N