Watson-Marlow Qdos30 Universal - Manual (Page 11)

Watson-Marlow qdos30 Universal and Universal+ Pump User Manual 11
Pump specifications
Flow Range (flow control) 0.1-500 ml/min (5000:1)
Supply voltage/frequency ~100-240V 50/60Hz
±10% of nominal voltage.
Maximum voltage fluctuation
An electrical mains supply is required
along with cable connections to the best
practice of noise immunity
Installation category
(overvoltage category)
II
Power consumption 190VA
Enclosure rating IP66 to BS EN 60529
NEMA 4X to NEMA 250*
Operating temperature range 4C to 45C, 41F to 113F
Storage temperature range -20C to 70C, -4F to 158F
Maximum altitude 2,000m, 6,560ft
Humidity (non-condensing) 80% up to 31C, 88F,
decreasing linearly to 50% at 40C, 104F
Pollution degree 2
Noise <70dB(A) at 1m
* Requires the fitting of the HMI protective cover
Standards
EC harmonised
standards
Safety requirements for electrical equipment for
measurement, control and laboratory use: BS EN 61010-
1 incorporating A2 Category 2, Pollution degree 2
Degrees of protection provided by enclosures (IP code):
BS EN 60529 amendments 1 and 2
Conducted emissions:
BS EN 55011 A1 and A2, Class A, called by BS EN 61000-6-4
Radiated emissions:
BS EN 55011 A1 and A2, Class A, called by BS EN 61000-6-4
Electrostatic discharge: BS EN 61000-4-2
Radiated RF immunity:
BS EN 61000-4-3 A1 and A2, called by BS EN 61000-6-2
Fast transient burst:
BS EN 61000-4-4 A1 and A2, Level 3 (2kV), called by BS EN 61000-6-2
Surge testing:
BS EN 61000-4-5 A1 and A2, called by BS EN 61000-6-2
Conducted RF immunity:
BS EN 61000-4-6, called by BS EN 61000-6-2
Voltage dips and interruptions:
BS EN 61000-4-11, called by BS EN 61000-6-2
Mains harmonics: BS EN 61000-3-2 A2
Pumps and pump units for liquids—common safety
requirements: BS EN 809
Other
standards
UL 61010A-1, UL/CSA 61010-1
CAN/CSA-C22.2 No 61010-1
IEC 61010-1
Radiated emissions FCC 47CFR, Part 15
NEMA 4X to NEMA 250
NSF61 for pumphead