Escient Adapter Kit CH-1 - Manual (Page 5)

Setup
Use the information in this chapter to set up and configure the CH-1 adapter kit
for use with your Vision system.
To get started you need to:
1. Properly configure your Vision VS or VC clients on your Ethernet network.
2. Properly configure your Sony changer
Important :
Read all of the following installation instructions carefully and completely before
you begin the installation.
Connecting the Adapters and Cables
Step 1: Power down your Vision
Press and hold the power button on the front panel for 5 seconds and then
release. Wait for the Vision to completely power off at which time the power LED
will go out. This may take a few seconds to complete.