Wavetronix Click 513 (traffic alert) (CLK-513) - Quick-reference Guide - Manual (Page 4)

© 2014 Wavetronix LLC. All rights reserved. Protected by US Pat. Nos. 6,556,916; 6,693,557; 7,426,450; 7,427,930; 7,573,400; 7,889,097; 7,889,098; 7,924,170; 7,991,542; 8,248,272;
8,665,113; and Cdn. Pat. Nos. 2,461,411; 2,434,756; 2,512,689; and Euro. Pat. Nos. 1435036; 1438702; 1611458. Other US and international patents pending. Wavetronix, SmartSensor, Click,
Command and all associated logos are trademarks of Wavetronix LLC. All other product or brand names as they appear are trademarks or registered trademarks of their respective hold-
ers. Product specifications are subject to change without notice. This material is provided for informational purposes only; Wavetronix assumes no liability related to its use.
WX-500-0197
Approaches Tabs
There is one sub-tab for each approach under the main Approaches tab. Each
enabled variable for the specified approach will qualify an interval if the de-
tected value exceeds the set threshold.
˽ Over Speed – qualifies if average speed is above set threshold
˽ Under Speed – qualifies if average speed is below set threshold
˽ Over Occupancy – qualifies if occupancy is above set threshold
˽ Under Occupancy – qualifies if occupancy is below set threshold
˽ Over Volume – qualifies if total volume is above set threshold
˽ Under Volume – qualifies if total volume is below set threshold
8
Run mode
9
Reset
To reset the Click 513, follow the steps below:
1 Hold the push-button down, then release when the red LED starts flashing.
2 Press the push-button to select. The first yellow LED will turn on to let you use that submenu.
3 Hold down the push button again to cycle between the following options:
˽ Yellow 1 – Resets all settings except Serial Number and XML variable map
˽ Yellow 2 – Resets all settings except Serial Number
4 Release when you reach the one you want. Press the push-button to select.
After the device is reset, it will return to the last mode that it was in.
Once the device has been configured, set it to Run mode to start retrieving traffic data.
1 Hold the push-button down, then release when the blue LED turns on.
2 Press the push-button to select. The red and blue lights will turn on, and the yellow light will flash as
data is received.
In run mode the Click 513 polls data from the SmartSensor HD on the RS-485 T-bus port and compares the
detected values to the thresholds set in Click Supervisor. You can use a serial terminal program to view text
status information on your computer.
Note. The Click 513 communicates at 9600 bps.
Output Tab
˽ Time Zone – Allows you to select the appropri-
ate time zone.
˽ Morning/Afternoon Start/Stop Time – Begin-
ning and end times that the alerts will operate to
turn on/off during the morning/afternoon hours.
Lanes Tab
There is one sub-tab for each lane under the main
Lanes tab. Each enabled variable for the specified
approach will qualify an interval if the detected value
exceeds the set threshold. The settings are the same as
the Approaches tab.