Welltech LP-803 Installation - Manual

LP803 Quick Installation Guide
Front View Rear View
CAUTION : Power input is DC 5Volt
Installation environment:
Install both WAN port of LP803 and PC Computer at the same IP Switch or
HUB.
Configure LCD of LP803 as follows.
MENU : Enter configuration or go back to previous page.
OK Key : Confirm setting
Navigation key : Select desirable features during configuration
1. Press MENU key from LCD Panel to configure NETWORK
environment
Setup IP Mode:
Go to [4] Network
Æ
[1] WAN Setup
Æ
[1] IP Type
Fixed IP client : Static IP address
DHCP client : Dynamic IP client mode
PPPoE client : ADSL Dial up Modem
How to configure WAN port to static IP address from LCD panel ?
Step 1 : Go to [4] Network Æ [1] WAN Setup Æ [1] IP Type Æ [1] Fixed IP Client. Press
1