Welltech SIPPBX 6200A - Manual (Page 75)

3.1.14 T.38 FAX
To change your T.38 FAX, click Configuration, and then click the T.38 FAX table. The
screen appears as shown.
Figure Configuration: T.38 FAX
The following table describes the table in this screen
Table Configuration: T.38 FAX
Label Description
Mode Select Enable option if you will use T.38 FAX function. The
default is Enable.
T.38 Start Port Enter the Start Port Number. The default is 4000.
T.38 End Port Enter the End Port Number. The default is 4999.
T.38 Redundancy Enter the Redundancy count. The default is 2.
Apply Click on the Apply button to save your customized settings and
exit this screen.
Cancel Click on the Cancel button to begin configuration this screen
afresh.
- 75 -