Epson RTC-4543SB - Manual (Page 11)

RTC - 4543 SA/SB
Page - 8 MQ - 252 - 03
7-3. Data writes (Divider Reset)
CLK
WR
DATA s40 s20 s10 s8 s4 y8 y10 y20 y40
CE
y80
1 52 2
N Seconds
s1
Divider reset
Pulse
s2
Timer,counter N seconds N seconds 0 seconds
Carry stop
Pulse
After the counter is reset, carries to the seconds digit are halted.After the data write operation,
the prohibition on carries to the seconds counter is lifted by setting the CE pin low.
Complete data write operations within tCE (Max.) = 0.9 seconds, as described earlier.
7-4. FOUT output and 1 Hz carries
CLK
WR
CE
1Hz
FOUT
CLK t
CES t
1.0 s
0
-7.8 ms
15.6 ms 15.6 ms
During a data write operation, because a reset is applied to the Devider counter (from the 128 Hz
level to the 1 Hz level) after the CE pin goes high during the time between the falling edge of the first
clock cycle and the rising edge of the second clock cycle, the length of the first 1 Hz cycle after the
data write operation is 1.0 s +0 / − 7.8ms + t
CES + t
CLK. Subsequent cycles are output at 1.0-second intervals.
The 1-Hz signal that is output on FOUT is the internal 1-Hz signal with a 15.6-ms shift applied.