Airaid 200-168 - Manual

Installation Instructions
For Part Numbers:
200-168
700-469 Airaid Oiled Media Filter
201-168 701-469 SynthaMax Dry Media Filter - Red
202-168 702-469 SynthaMax Dry Media Filter - Black
203-168 703-469 SynthaMax Dry Media Filter - Blue
2006 Chevrolet Silverado 1500
2007 Chevrolet Silverado Classic 1500
2005-06 Chevrolet Silverado 1500HD/2500HD/3500
2007 Chevrolet Silverado Classic
1500/1500HD/2500HD/3500
4.3L V6, 4.8L V8, 5.3L V8, 6.0L V8, 8.1L V8
Component Identification
1. Airaid Premium Filter 1
2. Rear Air Dam Coated 1
3. MAF Panel Coated 1
4. Filter Adapter 1
5. Weather Strip 21” 1
6. 6-32x 5/16” Screw 5
7. #6 Flat Washer 5
8. 6-32 Keps Nut 5
9. ¼-20 x ½” Button Head Bolt 3
10. ¼” Flat Washer 7
11. M6-1x25 Hex Bolt 4
12. 7 ¼” Rubber Trim 1
1. Disconnect the negative battery cable.
Loosen the 2 hose clamps located at
the Mass Air Flow (MAF) meter. 2. Disconnect the MAF meter wiring harness,
and remove the meter from the factory intake
tube. 3. Remove the factory air filter lid, intake
tube, and base from the vehicle as an assem-
bly. (Hint: pull straight up on the air filter
base to remove, there are no bolts, just grom-
mets).
8. Position the Airaid Cool Air Dam in place
of the factory air box. Secure it to the factory
mounting pad using four M6-1x25 bolts
(#11) and ¼” flat washers (#10). (Caution:
over tightening may distort the cool air dam! 9. Slide the factory MAF meter onto the
filter adapter. Tighten the hose clamp.
(Note: The factory clamp / rubber bushing
must be in place on the inlet to the MAF
meter.) Reconnect the factory intake tube,
MAF meter wir ing har ness, and tighten
the clamps.
MAF Meter
7. Install the filter adapter (#4) using three ¼-
20 x ½” button head bolts (#9) and ¼” flat
washers (#10).
4. Using a 10mm socket, remove the five
bolts that secure the factory air filter hous-
ing platform and remove it. 5. Assemble the Airaid Cool Air Dam pan-
els (#2, #3) using five 6-32x 5/16” screws
(#6), #6 flat washers (#7) and 6-32 keps
nuts (#8). 6. Install the 7¼” rubber trim (#12) onto the
side of the Airaid Cool Air Dam.
Full color instructions can be viewed on our web site at Airaid.com. Use the Product Search function to find your part number, and click View Details.