Airaid 200-196 - Manual

Installation Instructions
For Part Numbers:
200-196
700-469 Airaid Oiled Media Filter
201-196 701-469 SynthaMax Dry Media Filter - Red
202-196 702-469 SynthaMax Dry Media Filter - Black
203-196 703-469 SynthaMax Dry Media Filter - Blue
2007-08 Cadillac Escalade/ESV/EXT
2007-08 Chevrolet Avalanche
2007-08 Chevrolet Silverado 1500/2500HD/3500HD
2007-08 Chevrolet Tahoe/Suburban 1500/2500
2007-08 GMC Sierra 1500/2500HD/3500HD
2007-08 GMC Yukon/Yukon XL 1500/2500
2007-08 GMC Denali/Denali XL
4.3L V6, 4.8L V8, 5.3L V8, 6.0L V8, 6.2L V8
(GMT-900 Body Style Only)
Component Identification
1. Airaid Premium Filter 1
2. MAF Panel Coated 1
3. Rear Air Dam Coated 1
4. Black Filter Adapter 1
5. Weather Strip 20 3/4” 1
6. 1/4”-20x1/2” SS Button Head 3
7. 1/4” Flat Washer 7
8. M6 x 1.25 Hex Bolt 4
9. 6-32 x 5/16” Screw 5
10. #6 Flat Washer 5
11. 6-32 Keps Nut 5
1. Disconnect the negative battery cable.
Loosen the hose clamp on the end of the factory
intake tube at the Mass Air Flow sensor, next
loosen the hose clamp that holds the Mass Air
Flow sensor to the factory air box. 2. Remove the Mass Air Flow sensor from be-
tween the factory intake tube and the factory air
box. Use caution to retain the rubber coupler on
the Mass Air Flow sensor. 3. Without disconnecting the wiring harness,
set the Mass Air Flow sensor out of the work
area. Next rock the factory air box back and
forth, lift it up, and remove it from the hold
down grommets. There are no bolts holding it
down.
4. Remove the factory air box from the vehicle. 5. Remove 4 bolts, and remove the factory air-
box mounting plate. 6. Assemble the two Cool Air Dam panels (#2)
and (#3) using the five supplied screws (#9),
washers (#10), and nuts (#11), as shown.
7. . Install the filter adapter (#4) into the CAD
using three button head bolts (#6), and washers
(#7). 8. Install the assembled CAD in place of the fac-
tory airbox using four bolts (#8) and washers
(#7). Do not over tighten the bolts.
9. Re-install the Mass Air Flow sensor and cou-
pler onto the air filter adapter (#4), as shown and
tighten the hose clamp. Next re-connect the fac-
tory intake tube to the Mass Air Flow sensor,
and tighten the hose clamp.
Full color instructions can be viewed on our web site at Airaid.com. Use the Product Search function to find your part number, and click View Details.