Airaid 200-280 - Manual

Component Identification
1. Airaid Premium Filter 1
2. Airaid Intake Tube 1
3. Cold Air Box 1
4. Filter Adapter 1
5. Urethane Hump Hose 1
6. Coupler w/ #68 Hose Clamp 1
7. 3/8”x 8” Breather Hose 1
8. Weather Strip 25” 1
9. 8-32 x 1/2” Button Head Screw 2
10. 1/4-20 x 1/2” Button Head Screw 3
11. 1/4-20 x 3/4” Button Head Bolt 1
12. ¼” Flat Washer 3
13. #64 Hose Clamp 2
14. 1/4 NPT x 3/8 Barbed Fitting 1
15. Edge Clip Cable Tie 1
Installation Instructions
For Part Numbers:
200-280 720-472 Airaid Oiled Media Filter
201-280 721-472 SynthaMax Dry Media Filter - Red
202-280 722-472 SynthaMax Dry Media Filter - Black
203-280 723-472 SynthaMax Dry Media Filter - Blue
2011-15 Chevrolet Silverado 2500HD/3500HD
2011-13 Chevrolet Suburban 2500
2011-15 GMC Sierra 2500HD/3500HD
2011-13 GMC Yukon XL 2500
6.0L V8 *With Mechanical Cooling Fan*
1. Disconnect the negative battery cable.
Remove the engine cover by simply pulling up on it and
sliding out from the vehicle. 2. Pull the PCV breather line from the factory intake
tube. 3.A.) Loosen the clamps securing the factory intake tube
to the throttlebody and the airbox.
B.) Separate the hose anchor from the factory intake and
remove the factory tube.
4. Remove the plastic PCV breather line from the facto-
ry hard line. A standard screwdriver works well for de-
pressing the locking tab in the coupling. 5. Disconnect the Mass Air Flow or MAF sensor ( A )
and the Manifold Absolute Pressure or MAP sensor
( B )Remove the factory airbox from the vehicle.
The airbox is secured to the vehicle with grommets and
simply lifts out.
6. Remove the four tray bolts and the airbox mounting
tray. Three of the bolts will be reused in step 9. 7. Secure the wiring harness to the inner fender as
shown using the Edge Clip Cable Tie (#15). 8. Install the Filter Adapter (#4) onto the Cold Air Box
or CAB (#3) as shown using the three 1/4-20 Button
Head Screws (#10) and 1/4” Flat Washers (#12).
A.) Transfer the MAF sensor from the factory airbox
into the Filter Adapter. Secure the sensor using the two
8-32 Button Head Screws (#9).
B.) Transfer the MAP sensor from the airbox into the
Filter Adapter and secure using the 1/4-20 x 3/4” Button
Head Bolt (#11).
Do Not Use Factory Hardware.
A
A
C
A.) MAF
B
A
B
B.) MAP
Full color instructions can be viewed on our web site at Airaid.com. Use the Product Search function to find your part number, and click View Details.
4. On 2015 Models: Remove the two 6mm bolts in the
fender brace and set the bolts and brace to the side.