Airaid 300-150 - Manual

Installation Instructions
For Part Numbers :
300-150 700-445 Airaid Oiled Media Filter
301-150 701-445 SynthaMax Dry Media Filter - Red
302-150 702-445 SynthaMax Dry Media Filter - Black
303-150 703-445 SynthaMax Dry Media Filter - Blue
2003-05 Dodge Ram 1500/2500/3500
5.7L V8
Component Identification
1. Airaid Premium Filter 1
2. Cool Air Dam 1
3. Weather Strip 33 ¼” 1
4. Modular Intake Tube 1
5. Urethane Hump Hose 1
6. Urethane Coupler 1
7. #16 Speed Clamp 2
8. #19 Speed Clamp 1
9 #22 Speed Clamp 2
10. #24 Speed Clamp 1
11. Black Rubber Cap Large 1
12. Black Rubber Cap Small 1
13. #60 Hose Clamp 4
14. Rubber Grommet 1
15. ½” x 4 ½” Hose 1
16. Black Connector Fitting 1
Full color instructions can be viewed on our web site at Airaid.com. Use the Product Search function to find your part number, and click View Details.
1. Disconnect the negative battery
cable, and remove the factory
“accordion” style intake hose by
loosening the two factory clamps. 2. Loosen the two 10mm bolts secur-
ing the factory resonator to the intake
manifold. 3. Disconnect the air temperature
sensor connector on the front of the
factory resonator. Next, twist the
temperature sensor and remove it
from the factory intake resonator.
(Retain for later use with Airaid in-
take). 4. 2003 Models: Disconnect &
remove the crankcase vent hose
from the front of the factory reso-
nator.
5. 2004-05 Models: disconnect
breather hose from factory air box
lid. 6. Remove the factory resonator and
rubber seal from throttle body. 7. Unclip & remove the factory air
box lid and factory air filter. 8. Position the Airaid Cool Air Dam
in place of the original air box lid.
Snap in place.
9. Mount the Airaid Premium filter
inside the Cool Air Dam & secure
with hose clamp provided. 10. 2003 Models Only: Slip the
black rubber cap over the nipple on
the Cool Air Dam and secure using
the #19 black speed clamp provided. 11. 2004-05 Models Only: Mount
factory breather hose to the nipple on
the Cool Air Dam and secure using
the #24 black speed clamp provided. 12. Install the rubber grommet into
the hole on the back side of the
Airaid tube & insert the factory air
temp sensor into grommet.