Airaid 300-198 - Manual

Installation Instructions
For Part Numbers:
300-198
720-432 Airaid Oiled Media Filter
301-198 721-432 SynthaMax Dry Media Filter - Red
302-198 722-432 SynthaMax Dry Media Filter - Black
303-198 723-432 SynthaMax Dry Media Filter - Blue
2006-10 Chrysler PT Cruiser
2.4L I4 Non Turbo
Component Identification
1. Airaid Premium Filter 1
2. Rear Panel 1
3. Front Panel 1
4. Rubber Elbow 1
5. Reducer Bushing 1
6. Weather Strip 25 1/2” 1
7. #48 Hose Clamp 2
8. 6-32x 5/16” Screw 4
9. #6 Flat Washer 4
10. 6-32 Keps Nut 4
1. Disconnect the negative battery cable.
Slide the red tab up on the temperature sensor, and
then squeeze the black tab at the top of the sensor,
and disconnect the wiring harness from the tempera-
ture sensor. Next loosen the two hose clamps at
each end of the factory intake tube. 2. Unhook the two metal clips that hold the fac-
tory air cleaner lid to the base of the air cleaner
box. 3. Remove the factory air cleaner lid by lifting up
on the front, and then sliding the tabs out of the
back of the air cleaner base.
4. Remove the factory air filter from the base of
the air cleaner box. 5. Remove the factory air intake tube from the
throttle body. 6. Carefully remove the temperature sensor from
the factory intake tube and set it aside, it will be re-
used in step #10.
7. Assemble the Quick Fit Panels (#2 & #3) as
shown, using the four provided screws (#8), wash-
ers (#9), and nuts (#10). 8. Install the three tabs of the assembled Quick Fit
Panel into the three slots on the back of the factory
air cleaner base, adjust the panels to fit in the slot
around the top of the base, and re-latch the two
factory clips to secure the panels to the base. 9. Install the reducer bushing (#5) into large end of
the rubber elbow (#4).
Full color instructions can be viewed on our web site at Airaid.com. Use the Product Search function to find your part number, and click View Details.
C.A.R.B. E.O. Number Applies Only
To Listed Vehicles Up Thru 2008
Models All Others Pending