Airaid 310-158 - Manual

Installation Instructions
For Part Numbers:
310-158 700-456 Airaid Oiled Media Filter
311-158 701-456 SynthaMax Dry Media Filter - Red
312-158 702-456 SynthaMax Dry Media Filter - Black
313-158 703-456 SynthaMax Dry Media Filter - Blue
1997-06 Jeep Wrangler
4.0L I6
Component Identification
1. Airaid Premium Filter 1
2. MAF Panel Black 1
3. Bottom Panel Black 1
4. Airaid Intake Tube 1
5. Weather Strip 27 “ 1
6. Urethane Hump Hose 1
7. Reducer Coupler 1
8. 1/4” Flat Washer 3
9. #6 Flat Washer 4
10. 6-32 Keps Nut 4
11. 6-32 x 5/16” Screw 4
12. ¼-20 x ½” Hex Bolt 1
13. ¼-20 x 7/8” Hex Bolt 1
14. ¼-20 Hex Nut 1
15. Grommet 1
16. Grommet 1
17. Grommet 1
18. ½”x7” Rubber Hose 1
19. #72 Hose Clamp 2
20. #44 Hose Clamp 2
21. Bracket 1
22. Black Speed Clamp 2
Full color instructions can be viewed on our web site at Airaid.com. Use the Product Search function to find your part number, and click View Details.
1. Disconnect negative battery cable.
Remove factory valve cover breather
hose from intake tube and discard. Re-
tain plastic valve cover fitting for later
use. 2. Loosen hose clamps on both ends of
factory intake tube. Remove intake tube
from engine. 3. 2005-06 Vehicles:
Disconnect the electrical connector to the
air temp sensor on the backside of the fac-
tory intake tube and remove sensor. Retain
sensor for later use. 4. Remove factory air filter from airbox.
5. Using a 5/16” socket, remove the
three nuts and bolts mounting the factory
air filter housing to inner fender. Re-
move air filter housing. 6. Using a 7/16” socket, remove the fac-
tory radiator mount bolt. Retain bolt for
later use. 7. Using a flat blade screwdriver, push
locking tabs inward to remove the fuse
panel from the mounting bracket. Posi-
tion panel out of the way to access the
bolt underneath. 8. Using a 10mm socket, remove one
bolt from the inner fender as shown
above. Retain bolt for later use.
9. Using a 13mm socket, remove the
radiator rod support bolt on the passen-
ger side. Retain bolt for later use. 10. Using the supplied hardware, assemble the
Airaid Cool Air Dam assembly as shown
above. 11. Using the supplied thin grommet,
position it over the passenger side radia-
tor support rod as shown above. 12. Carefully slide the Airaid Cool Air
Dam assembly over the passenger side
radiator support rod. Be careful not to
scratch the paint. Insert the rubber
grommet into the panel for final posi-
tioning of the assembly.