Extron Electronics MTPX Series - Manual (Page 23)

Refer also to the MTPX User’s Manual at www.extron.com. Refer also to the MTPX User’s Manual at www.extron.com.
Optimizing the video
Most MTP transmitters and half of the MTPX TP outpust have a
pre-peaking feature. Many MTP receivers have level/peaking
and skew adjustments. Set these features as follows for the best
image quality:
1
. For inputs from MTP T 15HD products only — If the
cable between the MTP transmitter and the MTPX Plus
is > 300', turn the transmitter’s Pre-Peak switch on. For
shorter cables, turn the switch off.
2 . For outputs — If the cable between the MTPX and the
receiver is > 300', turn the MTPX’s Pre-Peak feature on.
For shorter cables, turn the feature off. Set the feature as
follows:
a
. In the Matrix Switchers Control Program, click Tools >
MTPX Config settings and then check or uncheck the
appropriate Pre-Peaking box.
N MTPX Pre-Peak is available on the first half of the MTPX
Plus outputs (for example outputs 1 through 4 for an
MTPX Plus 168.
N Unless the TP cable lengths are changed, these settings
should need to be made only once, during installation.
3 . If level/peaking and skew adjustments are available on
the connected receiver(s)
, set them in accordance with the
applicable MTP product manual.
MTPX • Remote Control and Optimizing the Video
Remote Control and Optimizing the Video, cont’d
4-12 MTPX • Remote Control and Optimizing the Video 4-13