Extron Electronics MTPX Series - Manual (Page 7)

Refer also to the MTPX User’s Manual at www.extron.com. Refer also to the MTPX User’s Manual at www.extron.com.
Twisted Pair (TP) Cable Transmission Distance
C Do not connect this device to a computer data or
telecommunications network.
The maximum distance is determined by the frequency and
resolution of the signal that is input to the transmitter or to one
of the matrix switcher’s local inputs. The table below specifies
the recommended maximum transmission distances using
Extron Enhanced Skew-Free A/V UTP cable or UTP CAT 5, 5e,
or 6 cable, terminated with RJ-45 connectors.
Recommended transmission distances at 60 Hz
Video format MTPX Pre-Peak Maximum distance
On Off High
quality
Variable
quality
Component,
S-video,
composite
<350'
(100 m)
>400'
(120 m)
800'
(245 m)
1,000'
(300 m)
640 x 480 <350'
100 m)
>400'
(120 m)
700'
(215 m)
750'
(230 m)
800 x 600 <350'
(100 m)
>400'
(120 m)
550'
(168 m)
650'
(200 m)
1024 x 768* <350'
(100 m)
>400'
(120 m)
500'
(150 m)
600'
(185 m)
1280 x 1024* <350'
(100 m)
>400'
(120 m)
350'
(100 m)
450'
(135 m)
1600 x 1200* <350'
(100 m)
>400'
(120 m)
300'
(90 m)
450'
(135 m)
N For any transmission distances above 350 ' (100 m), turn
on the transmitting device's (MTP transmitter or MTPX)
prepeak function. See the MTP Transmitter/Receiver
User's Manual and/or the Output Pre-Peaking SIS
commands on page 4-4.
N Resolutions marked with an asterisk (*) in these tables
have the same range specifications at 75 Hz.
N The minimum TP cable length should be 50 ' (15m).
N It is possible to exceed the recommended distance; however,
image quality may be reduced.
N The MTPX output can be extended by 50 feet (15 m) for
those outputs that have a Pre-Peak feature that is turned on.
N The transmitters, receivers, and matrix switcher are
designed for and perform best with Extron Enhanced
Skew-Free A/V cable terminated in accordance with
the TIA/EIA T 568 A wiring standard. CAT 5, 5e,
and 6 cables are acceptable, but less preferable. We also
recommend the use of preterminated and tested cables.
Cables terminated on site should be tested before use to
ensure that they comply with Category 5 specifications.
N The recommendations shown on the preceeding page
apply equally for a transmission line consisting of a
single transmitter, the switcher, and receiver; and for a
transmision line that encompass a transmission daisy
chain. For example, the maximum suggested range for
1024 x 768 video is 350’ (100 m) with Pre-Peak off and
400’ (120 m) with Pre-Peak on whether the transmission
line consists of the transmitter, switcher, and a single
receiver or a transmitter, the switcher, and three daisy-
chained receivers.
N For daisy-chained units, the first receiver in the chain
should be at least 50’ (15 m) from the switcher when the
Pre-Peak feature is on.
N For daisy-chained units, any receiver in the chain closer
than 350’ (105 m) may experience some form of over-
peaking when the Pre-Peak switch is on.
MTPX • Introduction
Introduction, cont’d
1-4 MTPX • Introduction 1-5