Airaid 510-302 - Manual

Installation Instructions
For Part Numbers:
510-302 700-462 Airaid Oiled Media Filter
511-302 701-462 SynthaMax Dry Media Filter - Red
512-302 702-462 SynthaMax Dry Media Filter - Black
513-302 703-462 SynthaMax Dry Media Filter - Blue
2010-15 Toyota 4Runner
2010-14 FJ Cruiser
4.0L V6
2. Remove the factory intake.
A.) Pry the wire harness anchor from the intake resona-
tor chamber
B.) Remove the 6mm anchor bolt from the resonator.
C.) Disconnect the crankcase breather and fuel pressure
regulator lines.
D.) Loosen the clamps on both ends of the intake tube
and remove the entire intake/resonator assembly. 3. Disconnect the Mas Air Flow sensor and remove the
factory airbox top and air filter.
4. Pry the wire harness anchor from the airbox. Remove
the three anchor bolts in the lower half of the airbox and
remove it from the vehicle. Remove the factory intake
tube bracket from the valve cover. It will not be reused. 5. Install the three M8 CAB Mounts (#13), hand tight,
into the weld nuts on the inner fender as shown. Note:
One of the original air box mounting holes is not re
used. 6. Apply the self adhesive, Foam Weatherstrip (#9) onto
the air inlet on the Cold Air Box (#3).
8. Transfer the Mass Air Flow sensor from the factory
airbox, into the Airaid Intake tube and secure using the
two #8 Spacers (#18) and 8-32 Socket Head screws
(#22) . Do not use the factory screws. 7. Mount the Filter Adapter (#5) to the Cold Air Box, as
shown, using three 1/4-20 x 1/2” Button head Bolts
(#16) and 1/4” Flat Washers (#17).
B.
D.
Component Identification
1. Airaid Premium Filter 1
2. Airaid Intake Tube 1
3. Cold Air Box 1
4. Air Box Lid 1
5. Filter Adapter 1
6. Hump Hose 1
7. Reducing Coupler 1
8. Airbox Gasket 1
9. Foam Weather Strip 1
10. 1/8 x 17” Vacuum Line 1
11. 1/8 NPT Barbed Fitting 1
12. 3/8 NPT Barbed Fitting 1
13. M8 CAB Mount 3
14. 8 mm x 1.25 x 16 Bolt 3
15. 5/16 Flat Washer 3
16. 1/4-20 x 1/2 Button Head Bolt 7
17. 1/4 Flat Washer 7
18. #8 spacer 2
19. #48 Hose Clamp 1
20. #64 Hose Clamp 1
21. #68 Hose Clamp 2
22. 8-32 Socket Head Screw 2
Note: Installation of this intake system requires
some minor trimming of the engine cover if it is
to be reused.
Disconnect The Negative Battery Terminal.
1. Remove the engine cover.
Lift up on the front of the engine cover to unseat the
mounting grommets and remove it from the vehicle.
C.
A.
SPACER
7. Mount the Cold Air Box onto the CAB Mounts us-
ing the three 8mm Bolts (#14) and 5/16 Flat Washers
(#15).
Not Used
Full color instructions can be viewed on our web site at Airaid.com. Use the Product Search function to find your part number, and click View Details.