Airaid 883-282 - Manual

Installation Instructions
For Part Number:
883-282 Intake kit with scoop
2008-14 Polaris Ranger RZR 800
1. Many of the panels needing to be removed for this
installation are held in place with the use of nylon riv-
ets. Nylon rivets are reusable if care is taken during
their removal and installation. Using a small standard
blade screwdriver, gently pry up on the center post until
the entire rivet can be pulled freely from the panel. Riv-
et installation is the opposite. 2 Place the range selector in Park. And remove both driv-
er and passenger seats. Disconnect the negative terminal
on the battery.
3. Remove the front engine cover by rotating the two
twist locks counter clockwise and lifting out.
4. Remove the bed bolts
A.) Using a 1/2” socket, r emove the four inner bed
bolts.
B.) Using a T-25 Torx driver, remove the four outer
bed bolts. 5. Using a T-25 Torx driver and a 7/16” wrench, remove
the two outer bed bolts.
7. The bed is fastened from underneath by four Phillips
head screws in these locations. Remove these screws
on both the driver and passenger sides of the vehicle. 6. Using a T-25 Torx driver, remove the four outer bed
bolts. 8. Under side view of three bed screws to remove.
Advisory Note:
Please read these installation instruc-
tions in their entirety before begin-
ning the install process. Airaid strong-
ly recommends the use of Locktite®
242 Medium strength threadlocker on
all threaded fasteners.
A.
B. B.
Tools Required For Installation:
7/16” and 1/2” Wrenches. 10mm, 7/16”, and
1/2” Sockets.
T-25 Torx driver. Ratchet & Extension. 1/8”&
5/16” Drill bits. 3” hole saw and drill. Center
punch and Mallet
Phillips and Standard Tip Screwdrivers.
Locktite ® 242 or equivalent, and a roll of tape
Full color instructions can be viewed on our web site at Airaid.com. Use the Product Search function to find your part number, and click View Details.
Page 1