Airaid 200-589 - Manual (Page 2)

2
Installation Instructions. Read Me!
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove throttle body air intake system.
3. Remove bolts, nuts, and studs from throttle body and manifold (Ref. “B”).
4. Install power plate using (4) 6mm bolts (Ref. “B”).
5. Install (1) extension plate using (1) 6mm flat head screw (Ref. “C”).
6. Inspect & Test throttle linkage for full open & closed travel before driving. Some cruise or kick-
down cables may require adjustment. Refer to service manual for proper adjustment.
7. Reinstall air intake system using (Step 2) as an example.
* Note: Use furnished 6mm x 30mm bolt & 6mm washer for air box support.
8. Reconnect battery cable. Enjoy!
The sound of power...The “whistle” means its working!
Ref. A- Power Plate
“O” Ring
Ref. B- Bolts 6mm x 75mm (Top)
Bolts 6mm x 60mm (Bottom)
Extension Plate
Flat Head Screw 6mm x 20mm
Bolt 6mm x 30mm (Air box Support)
Ref. C- Flat Washer 6mm (Air box Support)
AIRAID Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951 [email protected] www.airaid.com
Rev. 12-04-06