Airaid 200-606 - Manual

Parts List
#1 Poweraid Spacer x1
#2 6mmx65mm Bolts x4
#3 6mm Flat Washers x4
#4 Fiber Gasket
x1
#5 3/4” Extension Plate x1
#6 6mm Flat Head Bolt x1
Installation Instructions
Part Number 200-606
Poweraid Spacer For
2014-2015 Chevrolet Silverado
2500/3500
2007-2013
Chevrolet Silverado 2500/3500
GMC Sierra 2500/3500
GMT-900 Series Trucks & SUVs
4.8L, 5.3L, 6.0L, 6.2L
2008-09 Hummer H-2
05-06 Pontiac GTO 6.0L
06-08 Chevrolet Trailblazer 5.3L
06-08 GMC Envoy 5.3L
1. Disconnect the negative battery cable!
Lift up on the front of the and beauty cover and
remove it from the vehicle. Push down on the radia-
tor hose, and separate the tube from the plastic
clamp. 2. Disconnect the breather tube from the intake
tube, by gently pulling towards you. An O-ring is
all that holds it in place. Next loosen the hose clamp
on the intake tube at the throttle body, and at the
Mass Air Sensor, and remove the tube from the ve-
hicle.
Thank you for purchasing the Poweraid Throttle Body Spacer. Please read the instruction manual careful-
ly before proceeding with the installation. Contact AIRAID @ (800) 498-6951 8:00 AM - 5:00 PM MST Weekdays
for questions regarding fit or instructions that are not clear to you. Your Poweraid Throttle Body Spacer was care-
fully inspected and packaged. Check that no parts are missing, or were damaged during shipping. If any parts
are missing, please contact AIRAID.
3. With a 10mm socket remove the two nuts, and
the two bolts that hold the throttle body to the intake
manifold. Without disconnecting the wiring harness,
set the throttle body aside. 4. With a 4mm socket, remove the two studs that
held the throttle body to the intake manifold.
Tools Required For Installation
10mm Deep Socket
4mm, 5/16” Sockets
5/32” Allen Wrench