Airaid 300-637 - Manual

Parts List
#1 Poweraid Spacer x1
#2 6mmx51mm Screw x4
#3 6mm Flat Washer x4
#4 Gasket x1
Installation Instructions
Part Number 300-637
2011-15 Chrysler 300
2011-14 Dodge Avenger
2011-15 Dodge Charger
2011-15 Dodge Challenger
2011-14 Dodge Durango
2011-14 Jeep Grand Cherokee
2012-15 Jeep Wrangler
3.6L Pentastar V6
1. Disconnect the negative battery cable!
Lift up on the engine cover to unseat it from it’s mounting
grommets, remove it from the vehicle, and set aside.
Thank you for purchasing the Poweraid Throttle Body Spacer. Please read the instruction manual carefully before proceed-
ing with the installation. Contact AIRAID @ (800) 498-6951 8:00 AM - 5:00 PM MST Weekdays for questions regarding fit or instruc-
tions that are not clear to you. Your Poweraid Throttle Body Spacer was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, please contact AIRAID.
2. Disconnect the air temperature sensor from the air intake
tube, just forward of the throttle body.
These instructions depict an installation being performed on a Dodge Challenger and
are meant to be a guide for all other makes and models listed. While specific details may vary
from vehicle to vehicle, the general install procedure remains the same.