Airaid 310-618 - Manual

Parts List
#1 Poweraid Spacer x1
#2 Gasket x1
#3 6mm x 50mm Hex Bolts x4
#4 6mm Flat Washers x4
Tools Required For Installation
5/16” & 10mm Sockets
Ratchet & Extension
Flat Blade Screwdriver
Installation Instructions
Part Number 310-618
Poweraid Spacer For
2007-12 Dodge Ram & Dakota
2007-10 Dodge Nitro
2007-09 Jeep Commander
2007-09 Jeep Grand Cherokee
2007-12 Jeep Liberty
2007-09 Mitsubishi Raider
3.7L V-6
Thank you for purchasing the Poweraid Throttle Body Spacer. Please read the in-
struction manual carefully before proceeding with the installation. Contact AIRAID @ (800)
498-6951 8:00 AM - 5:00 PM MST Weekdays for questions regarding fit or instructions that
are not clear to you. Your Poweraid Throttle Body Spacer was carefully inspected and
packaged. Check that no parts are missing, or were damaged during shipping. If any
parts are missing, please contact AIRAID.
Thank you for selecting AIRAID.
1. Disconnect the negative battery cable!
2007-10 Jeep Liberty/Dodge Nitro: Using a
5/16” socket, loosen the hose clamp on the throttle
body end of the factory intake tube. Disconnect the
factory temperature sensor wiring harness by slid-
ing the red tab back, and then pressing the black
tab on the connector while sliding it off. Slide the
factory intake tube off of the throttle body. 2. All other listed vehicles: Using a 5/16” socket, or
flat blade screwdriver, loosen the hose clamp which
secures the factory intake tube to the resonator box.
Disconnect the factory temperature sensor wiring
harness from the sensor in the resonator box. Slide
the factory intake tube off of the resonator box. Re-
move the resonator box by pulling straight forward
to release it from the throttle body and the grommet
mounts. Save the resonator box for reuse.