Airaid 510-621 User Manual
Airaid Accessories for air
Parts List
#1
Poweraid Spacer
x1
#2
Gasket
x1
#3
6mm x 65mm Hex Bolts x4
#4
6mm Flat Washers
x4
Tools Required For Installation
Flat Blade Screwdriver
10mm Socket
Ratchet & Extension
Pliers
Installation Instructions
Part Number 510-621
Poweraid Spacer For
2007-14Toyota Tundra
2008-14Toyota Sequoia
5.7L V-8
2010-14 Toyota Tundra
2010-12 Toyota Sequoia
4.6L V-8
Thank you for purchasing the Poweraid Throttle Body Spacer. Please read the in-
struction manual carefully before proceeding with the installation. Contact AIRAID @ (800)
498-6951 8:00 AM - 5:00 PM MST Weekdays for questions regarding fit or instructions that
are not clear to you. Your Poweraid Throttle Body Spacer was carefully inspected and
packaged. Check that no parts are missing, or were damaged during shipping. If any
parts are missing, please contact AIRAID.
Thank you for selecting AIRAID.
1. Disconnect the negative battery cable!
Remove the engine beauty cover by lifting up on
the front, and then pulling it towards the front of
the vehicle. (Save for reuse).
2. Using a 10mm socket, loosen two hose clamps
on the factory intake tube. Slide the factory intake
tube off of the throttle body and airbox. Move the
factory intake tube aside, while leaving the factory
vacuum and breather lines connected .