Airaid 510-622 - Manual

Parts List
#1 Poweraid Spacer x1
#2 Gasket x1
#3 6mm x 65mm Hex Bolts x4
#4 6mm Flat Washers x4
Tools Required For Installation
Flat Blade Screwdriver
10mm Socket
Ratchet & Extension
Locking Pliers or Stud Remover
Installation Instructions
Part Number 510-622
Poweraid Spacer For
2007-08 Toyota Tundra
4.7L V-8
Thank you for purchasing the Poweraid Throttle Body Spacer. Please read the in-
struction manual carefully before proceeding with the installation. Contact AIRAID @ (800)
498-6951 8:00 AM - 5:00 PM MST Weekdays for questions regarding fit or instructions that
are not clear to you. Your Poweraid Throttle Body Spacer was carefully inspected and
packaged. Check that no parts are missing, or were damaged during shipping. If any
parts are missing, please contact AIRAID.
Thank you for selecting AIRAID.
1. Disconnect the negative battery cable!
Using a 10mm socket, remove the two nuts on
each end of the engine beauty cover. Remove the
engine beauty cover and set it aside (save for re-
use). 2. Using a 10mm socket, loosen the hose clamp on
the throttle body end of the intake tube. Slide the
intake tube off of the throttle body towards the
radiator.