Airaid 510-624 - Manual

Installation Instructions
Part Number 510-624
Poweraid Spacer For
2007-09 Toyota FJ Cruiser
2005-1
5 Toyota Tacoma
2005-09 Toyota 4Runner
4.0L V-6
Packing List:
#1 Poweraid Spacer x1
#2 Fiber Gasket x1
#3 6mmx75mm Bolt x4
#4 6mm Flat Washer x9
#5 6mmx20mm Bolt x2
#6 6mmx25mm Bolt x1
#7 6mmx40mm Bolt x1
#8 6mmx12mm Bolt x1
#9 1” Extension Plate (No C’Snk) x3
#10 5/16” Thick Spacer 1/4” Hole x1
#11 3/4” Thick Spacer 1/4” Hole x1
Tools Required For Installation:
4mm, 10mm Sockets
Ratchet and Extension
Pliers
Flat Blade Screwdriver
1. Disconnect the negative battery cable.
Using a 10mm socket, remove the two nuts that secure the factory beauty cover
to the engine. Remove the beauty cover and save it for reinstallation later. 2. A.) Using a 4mm socket, remove the two studs that secure the beauty cover to
the engine.
B.) Squeeze the tab on the Mass Air Flow sensor wiring connector and discon-
nect it from the Mass Air Flow sensor.
C.) Using a 10mm socket, remove two bolts that secure the resonator/airbox to
the engine.
3. A.) Using a 10mm socket, loosen two hose clamps, one at the throttlebody,
and one where the fresh air tube connects to the resonator/airbox.
B.) Disconnect the crankcase breather hose on the front of the resonator/airbox,
and the small vacuum line on the back. (not shown)
C.) Using a flat blade screwdriver, pry two wiring harness anchors from the reso-
nator/airbox. 4. Remove the complete resonator/airbox assembly from the vehicle.
Thank you for purchasing the Poweraid Throttle Body Spacer. Please read the instruction manual carefully before proceeding with the installation.
Contact AIRAID @ (800) 498-6951 8:00 AM - 5:00 PM MST Weekdays for questions regarding fit or instructions that are not clear to you. Your Poweraid
Throttle Body Spacer was carefully inspected and packaged. Check that no parts are missing, or were damaged during shipping. If any parts are missing,
please contact AIRAID.
A
B
C
A
B
C