Airaid 883-311 - Manual

Installation Instructions
For Part Number:
883-311 Snorkel kit for Airaid PN
883-306
2. Side the three small Loop Clamps (#10) onto the roll
cage A pillar as shown. 3. Mount the Snorkel Inlet(#3) to the Snorkel Tube (#2),
using the four Torx screws (#16), Torx Bit #18 and a
90deg. Low Profile Ratcheting Screwdriver.
4. Carefully insert the Airaid Foam Prefilter (#5) into the
Snorkel Inlet. 5. Install the Snorkel Screen (#4) onto the Inlet using
the four 8-32 Button Head Screws(15). 6. Attach the Snorkel Tube to the Loop Clamps using
three1/4-20 x 1 1/4 Bolts (#12), 1/4-20 Locknuts (#14),
and Flat washers (#13). Leave all hardware finger tight at
this time to allow for proper alignment
Component Identification
1. Airbox Lid 1
2. Snorkel Tube 1
3. Snorkel Inlet 1
4. Snorkel Screen 1
5. Foam Prefilter 1
6. 3” Flexible Duct, 40” 1
7. 3” Loop Clamp 2
8. 1/4-20 x 1/2” Button Head Bolt 2
9. 1/4-20 Speed Nut 2
10. 1 3/4” Loop Clamp 3
11. 1/4-20x 1 1/4” Bolt 3
12. 1/4” Flat Washer 6
13. 1/4-20 Nylock Nut 3
14. 8-32 x 3/8 Button Head Bolt 4
15. Torx Screw 4
16. # 48 Hose Clamp 1
17. Edge Trim, 10” 1
18. Torx Bit #20 1
19. Bubble Sticker 1
Tools Required For Installation:
In addition to common hand tools, installation of this kit re-
quires the use of a Jig Saw or equivalent. Low Profile Ratch-
eting Screwdriver.
1. Disconnect the negative battery terminal. Install
the Airbox Lid (#1) onto the Airaid performance Airbox
using The four 1/4-20 x 1/2” Button Heads Bolts and
1/4” Flat Washers from the Airaid 883-306 intake.
7. Close up of proper Snorkel hardware orientation. 8. Remove the Urethane Cap from the Airaid perfor-
mance Airbox. The Clamp will be reused in step #10,
the cap will not be reused. 9. Install Cut out the fender Template and tape it in posi-
tion on the corner of the passenger side hood as shown.
Full color instructions can be viewed on our web site at Airaid.com. Use the Product Search function to find your part number, and click View Details.