Airaid 1009 - Manual (Page 2)

Instructions Revision
11/12/10
5. Reinstall the intake tube and tighten the two hose clamps.
Reinstall the breather tube onto the intake tube. 6. Double check your work. Make sure there is no foreign ma-
terial in the intake tract. Make sure all clamps, hoses, nuts, and
bolts are secure. Reconnect the negative battery cable.
ECONOAID 2688 E Rose Garden Ln. Phoenix, AZ 85050 (888) 876-4676 www.ECONOAID.com
4. Reinstall the throttlebody onto the intake manifold using the
factory hardware. Tighten the nuts and bolts in a cross pattern
to the vehicle manufacturer’s specifications. Before starting
the engine, open and close the throttlebody to make sure there
are no obstructions. 3. Install the ECONOAID Throttlebody Booster and supplied
gasket between the throttlebody and the intake manifold with
the logo facing the front of the vehicle. Make sure that the
gasket is between the throttlebody and the ECONOAID. (If
your application does not have an O-ring on the intake mani-
fold, install the second supplied gasket between the
ECONOAID and the intake manifold).
ECONOAID
Fiber Gasket
1.
2.
3.
4.
Included with your ECONOAID Throttlebody Booster
is a decal with the California Air Resources Board
( C.A.R.B. ) Executive Order number D-520-4. This
decal must be placed in plain view inside the engine
compartment. Failure to do may prevent you from
passing a smog inspection.