Airaid 1017 - Manual (Page 2)

Instructions Revision
11/12/10
7. Double check your work. Make sure there is no foreign
material in the intake tract. Make sure all clamps, hoses, nuts,
bolts and connectors are secure.
Reconnect the negative battery cable.
ECONOAID 2688 E Rose Garden Ln. Phoenix, AZ 85050 (888) 876-4676 www.ECONOAID.com
5. Reinstall the air cleaner box onto the top of the throttle-
body. Reconnect the fresh air tube and tighten the clamp.
Tighten the clamp on the throttlebody. Reinstall the two bolts
that secure the airbox to the engine. Reconnect the Mass Air
sensor wiring harness.
ECONOAID
4. Reinstall the throttlebody onto the intake manifold and
tighten the two nuts and one bolt to the vehicle manufacturer’s
specifications. Before starting the engine, open and close the
throttlebody to make sure there are no obstructions. Reconnect
the two rubber hoses to the throttlebody. 3. Lift the throttlebody off of the intake manifold and remove
the old gasket. Install one supplied gasket against the intake
manifold, and then the ECONOAID Throttlebody booster
with the logo facing the throttlebody. Next install the remain-
ing gasket between the ECONOAID and the throttlebody.
Fiber Gaskets
Included with your ECONOAID Throttlebody
Booster is a decal with the California Air Re-
sources Board ( C.A.R.B. ) Executive Order
number D-520-4. This decal must be placed in
plain view inside the engine compartment. Fail-
ure to do may prevent you from passing a smog
inspection.