Allstar Performance ALL11300-02 - Manual

Allstar Performance 8300 Lane Dr., Watervliet, MI 49098
Phone: (269) 463-8000 Fax: (800) 772-2618 www.allstarperformance.com
Form 1141 Page 1 of 3 Rev. 010715
INSTRUCTIONS
Race Car Air Jacks
Kit Includes:
4-Lifting Cylinders
8-Cylinder Mounting Rings
16-Cylinder Mounting Nuts
4-Safety Stands
1-Air Lance
1-Air Lance Receptacle
1-Plumbing Kit
Additional Required Components:
400psi Regulator (ALL11310)
Hose Kit for Air Jack System (ALL11312)
Nitrogen tank (400psi Minimum Supply)
Lifting Cylinder Mounting:
Each cylinder in the kit includes four mounting nuts and two steel mounting rings which should be welded
and properly gusseted to the vehicle structure or chassis.
Tips to keep in mind when installing mounting rings:
• Front cylinders should be mounted as far forward on the car as possible, but positioned behind the front tires.
• Rear cylinders should be mounted towards the rear of car, positioned in front of the rear tires if possible.
• Position mounting rings in the middle of the threaded portion of the cylinder to allow final leveling adjustment.
• Mount the cylinders far off the vehicle center line to maintain stability while lifted.
• Mount the cylinders perpendicular to the floor in both directions.
• Mount the cylinders so the bottom of each foot is level to ensure stability while the vehicle is lifted.
Be sure to check that the foot rests flat on the floor when the vehicle is lifted.
• It is recommended that the cylinder be mounted so the cylinder foot is above the bottom of the
frame rail, or vehicle floor. This will help protect the cylinder from damage when not being used.
Cautions:
• Do not exceed 400 PSI of working pressure.
• Do not get under the lifted vehicle without first properly installing safety stands.
• Do not place cylinders or run lines in areas of high temperature.
• Do not pressurize the system if the foot of the lift is not near the floor.
• Do not clean lift tube with hydrocarbon or equivalent chemicals.
Recommended Plumbing
Rear of car
90 degree
fitting
High pressure
air tubing
T-fitting
3 ferrule
T-union
Front of car
90 degree
fitting T-fitting
Figure #1
To lance
receptacle