Allstar Performance ALL18205 - Manual

Allstar Performance 8300 Lane Dr., Watervliet, MI 49098
Phone: (269) 463-8000 Fax: (800) 772-2618 www.allstarperformance.com
Form 1058 Page 1 of 1 Rev. 040908
Rivet Gun For Drills
OPERATION INSTRUCTIONS
Specifications:
Drill Types - Cordless, Electric, or Pneumatic
Drill Size - 3/8" or Larger
Capacity - 3/32", 1/8", 5/32", or 3/16" Aluminum Standard Rivets
Weight - .617 Lbs
Length - 5.5"
Diameter - 2.4"
Minimum Cordless Requirements - 12 V or higher
ALL18205
INSTALLATION: Always use a reversible drill and set to drill position. Experiment with high and low speeds
to achieve best results. Open the drill chuck and insert the shank of ALL18205 (FIG. 1). Tighten the chuck se-
curely and cover with "telescopic" protective sleeve. Three nosepieces are included (use the same nosepiece
for 3/32" & 1/8" diameter rivets). Use the proper size nosepiece for the rivet being installed.
ALL18205 IS NOW READY FOR USE: Insert the rivet completely; being certain the drill is in the forward
position. Hold ALL18205 in your free hand to prevent spinning and actuate the drill trigger until the rivet
is set and the nail has broken free. Put the drill in the reverse position and hold the trigger until the nail is
released. Listen for a "click" as indication the drill is ready to accept another rivet.
MAINTENANCE: Clean and lubricate the jaws periodically, at least every 1,000 rivets. Lubricate the chuck
as needed. FIG. 3 shows the breakdown of internal parts. To dismantle, remove the threaded cap (#9) where
it connects to the nosepiece (#27), keep the control window "B" (FIG 2) open and turn to the left until the
chuck (#17) is removed, then remove the jaws (#12).
SAFETY GUIDELINES: ALL18205 is an adapter for power reversible drills. As with any tools, proper care &
maintenance must be performed to keep equipment in safe working order. The use of safety gloves & glass-
es is recommended. Do not wear loose fitting jewelry or garments that could get caught in this tool or drill.
Be sure ALL18205 is fitted onto the drill securely to prevent any break in equipment. If the drill is powered by
less than 500 watts, it may impair the capacity of the adapter as listed above.
FIG. 1
FIG. 2
FIG. 3