Allstar Performance ALL26009 - Manual

Allstar Performance 8300 Lane Dr., Watervliet, MI 49098
Phone: (269) 463-8000 Fax: (800) 772-2618 www.allstarperformance.com
Form 1117 Page 1 of 1 Rev. 071513
ASSEMBLY AND CLEANING OPERATION
Filter Cleaning Station
Assembly:
Bolt filter basket to the base stand using supplied hardware. Do not overtighten, filter basket should spin freely.
Contents:
Description Quantity
Base Stand 1
Filter Basket 1
Hex Bolt 1
Cleaning Operation:
Insert dirty air filter into the filter basket. Spray filter with a cleaner or
degreaser as recommended by filter manufacturer and allow to soak
for a few minutes or more as needed. Using a garden hose, spray to
the inside of filter in a downward direction at about 3-4 o'clock until
the filter basket begins to rotate. Flush until clean. The total cleaning
process should only take minutes depending on the condition of air
filter.
Allow filter to dry completely, rotating as necessary. Once filter is dry
use stand to rotate filter for even application of filter oil, if applicable.
Note: Cleaning operation is a basic guide. Always refer to OEM filter
cleaning instructions for specific cleaning and maintenance steps.
Caution:
• High pressure water can damage an air filter.
• Unit is for use with washable filter elements only.
• Paper element filters may be destroyed.
• During cleaning process, position stand away from anything electical. Basket rotation creates a secondary spray of water.
• Hold garden hose near the center of the filter to avoid contact with basket arms while they are rotating.
Filter Basket
Base Stand
Filter Not Included
Spray
Direction