Allstar Performance ALL26125-27 - Manual

Allstar Performance 8300 Lane Dr., Watervliet, MI 49098
Phone: (269) 463-8000 Fax: (800) 772-2618 www.allstarperformance.com
Form 1039 Rev. 050313
Follow These Steps:
1. Inspect mounting surface on rear of block. Occasionally, the factory does not finish machining the area above the two
upper mounting holes. If this is the case, use a file or deburring tool to smooth this area.
2. Install small diameter of alignment tool ALL26127 into rear main bearing housing bore without a bearing. The larger
diameter end of the installation tool will protrude from the rear of the casting to properly center adapter. Install the rear
main bearing cap and torque main bearing bolts to 50lb/ft.
3. Apply a light amount of oil on the protruding end of tool.
4. Apply a light film of RTV sealer to block contact half of adapter. At this point assemble the two halves of seal holder and
evenly tighten the retaining bolts so that the adapter will slide freely on the alignment tool without binding.
5. Gently push adapter against the block (CAUTION: DO NOT install O.E. alignment dowel in block.) making certain that
there is no movement of ALL26127 tool as you do so. NOTE: There may be a small difference in length between the oil
pan rail of the block casting and the seal holder; this is normal and will be taken up by the oil pan gasket and a small
amount of RTV sealer. DO NOT ATTEMPT TO ALTER THE ALIGNMENT OF THE SEAL HOLDER FOR THIS REASON.
6. Install Loctite #262 or equivalent on all four mounting bolts. Install bolts in rear of block casting and torque to
specifications in an appropriate sequential pattern.
7. Remove ALL26127 Installation Tool from rear main bearing journal by loosening rear main cap and sliding tool out the
backside of adapter plate.
8. Remove two recessed socket head cap screws holding two halves of adapter plate together to install both halves of rear
main seal.
Without the use of ALL26127 Alignment Tool or the appropriate use of a dial indicator to verify alignment
of the seal holder with the center line of the crankshaft, severe leaks and engine failure may occur.
ALL26125 ALL26126 ALL26127
Rear Main Seal Adapter
INSTALLATION INSTRUCTIONS
Due to irregularities in block and oil pans this adapter is not designed to use the original style rubber
rear oil pan seal. Apply a generous amount of RTV sealant to the trough of the adapter plate in place
of the rear pan seal for proper sealing. Note: Make sure sealing areas are clean and free of oil before
installation.