Allstar Performance ALL26700-08 - Manual

Allstar Performance 8300 Lane Dr., Watervliet, MI 49098
Phone: (269) 463-8000 Fax: (800) 772-2618 www.allstarperformance.com
Form 1084 Page 1 of 1 Rev. 112013
INSTRUCTIONS
TRANSMISSION OIL COOLER
WITH 3/8" BARBED FITTINGS
For maximum cooling efficiency, oil cooler should be installed in front of the radiator or air conditioning condenser. Cool air must
pass through the fins of the oil cooler either from a forced air source or the engine cooling fan drawing air through the oil cooler.
If the cooler must be installed behind the radiator or out of the cooling air of the belt driven fan, use the next larger size oil cooler.
The oil cooler can be mounted in any vertical, horizontal or diagonal position. Do not mount the cooler in a location where it may
be damaged by road debris.
INSTALLATION INSTRUCTIONS
1.
Place Nylon washers over the threaded machine bolts.
2. Gently push the four (4) nylon machine bolts through the fins of the oil cooler and slide a rubber spacer onto each screw.
3. Position the cooler in front of the car’s radiator and/or A/C condenser. When mounting cooler, consider the routing of the
auxiliary cooler lines.
4. Gently push the nylon machine bolts through the radiator and/or A/C condenser fins. Twist or turn the screw to ease
penetration between the fins without damaging the radiator tubes.
5. Slide a disk nut onto each screw until it touches the radiator or A/C condenser. Press the nut onto the shaft until snug.
Contents
Description Quantity Description Quantity
Transmission Oil Cooler 1 Nylon Disk Nut 4
Male Hose Adapter 1 Nylon Machine Bolt 4
4 Ft. Hose 1 Nylon Washer 4
Hose Clamp 4 Rubber Spacer 4
This cooler includes an adapter fitting for 5/16" inverted flare line, although this is the most popular fitting, it will not fit all applica-
tions. Other fittings are readily available at most parts suppliers.
When installing a cooler in addition to a radiator mounted cooler, plumb the cooler after the radiator cooler as shown in Figure #1.
Transmission Engine Radiator Oil Cooler
Oil Flow
Oil Flow
Figure #1
To identify the oil return line, it will be cooler than the
line which brings oil from the transmission to cooler.
Nylon
Disk Nut
Rubber
Spacer
Nylon
Washer
Nylon
Bolt