Amer Networks SR24G2 - Manual (Page 14)

8
I
DENTIFYING
E
XTERNAL
C
OMPONENTS
This chapter identifies all the major external components of the Switch. Both the front
and rear panels are shown below, with a description of each panel feature.
Front Panel
LED Indicators
10/100 BASE-T X Twisted-Pair Ports
1000 BASE-T
Twisted-Pair Ports
Figure 4. The front panel of the Switch
LED Indicators
Refer to the next chapter Understanding LED Indicators for detailed information
on the meaning of each LED indicator.
10/100BASE-TX Twisted-Pair Ports (Port1~24)
These ports supports network speeds of either 10Mbps or 100Mbps, and can
operate in half- and full- duplex transfer modes. These ports also support
automatic MDI/MDI-X crossover detection function which gives true “plug
and play” capability. Just plug-in the network cable to the hub directly since
there is no need to care if the end node is NIC (Network Interface Card) or
switches and hubs.
1000BASE-T Twisted Pair Ports (Port 25~26)
The Switch is equipped with two Gigabit twisted pair ports that are auto
negotiable 10/100/1000Mbps and auto MDI/MDIX crossover detection
supported. These two ports can operate in half- and full- duplex modes.